Mechatronics Exercises

Workspace Navigation

DIY suspension wizard - mountain bike suspension data logger

Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

The figure below shows the schematic of the device, note that the pins of the Nano 33 BLE are numbered according to their place not according to A0, A1, ..., D2, Rx.., the USB port is at the opposite end to the IC notch, e.g. between pins 15 and 16.

Note that the above figure applies perfectly only for the components mentioned in the components list in section 2. Especially the GPS serial wiring is opposite to standard serial, as the used module is designed to be used as a shield rather than a separate module. So in case you are using 'normal' GPS module the serial wiring should be gps(tx) → 2 (nano rx1) and gps(rx) → 1 (nano tx1).

3D printing specifications

...